Soil Moisture Detection Humidity Sensor ModuleSubtotal: ₨250
All Products
Showing 265–288 of 444 resultsSorted by popularity
- Arduino, Arduino Components, Sensors
Soil Moisture Detection Humidity Sensor Module
- Operating Voltage 3.3V-5V
- Module Dual Output mode , a simple digital output , analog output more accurate.
- With fixed bolt hole for easy installation
- Small PCB board size : 3cm * 1.6cm
- Power Indicator ( red ) and the digital switch output Indicator ( green )
- Using LM393 Comparator Chip , Stable
- VCC external 3.3V-5V
- GND GND External
- DO small board digital output interfaces ( 0 and 1 )
- AO small board analog output interface
SKU: n/a - Components, Programmer Components, Programmers, SPI Flash Memory
MXIC MX25L12835F Flash Memory Chip 128Mbit 16MB
Components, Programmer Components, Programmers, SPI Flash MemoryMXIC MX25L12835F Flash Memory Chip 128Mbit 16MB
- Memory
- 128Megabits = 16Megabyte (MB)
- Voltage
- 2.7V to 3.6V
This is MXIC 16MB SPI Memory Chip.
Can be used in thousands of supported devices. for example routers, dish receivers, set top boxes, CPEs, lcds, laptops etc
SKU: n/a - Memory
- 433 Mhz, Arduino, Arduino Components, Wireless
433Mhz RF Wireless Remote Control 2 Channel On Off
- This remote control only support the learning code (1527) of the receiver
- It can not clone other remote controls, it is only 1527 encoded remote control. (Fixed Code)
- Can only match the 1527 learning code receiver.
- Application: (Partial)
- Garage doors access control system
- Electronic gates access control system
- Electrical appliances control
- Vehicle central locking systems
- Car sunroofs control
- Heating systems control
SKU: n/a - Power, Tools
UNI-T UT203 Digital Clamp Multimeter Ampere Meter
Model: UT203
- AC Current (A): 40A/400A ±(2.5%+5)
- DC Current (A): 40A/400A ±(2%+3)
- AC Voltage (V): 4V/40V/400V/600V ±(1%+5)
- DC Voltage (V): 400mV/4V/40V/400V/600V ±(0.8%+1)
- Resistance (Ω): 400Ω/4kΩ/40kΩ/400kΩ/4MΩ/40MΩ ±(1%+2)
- Frequency (Hz): 10Hz~1MHz ±(0.1%+3)
SKU: n/a - Modules, Sensors
W1401 LED Digital Thermostat Temperature Control
- Digital Thermostat, Temperature Control Module can be used to control the temperature of anything (Solid or Liquid), Set the specific temperature you want to maintain.
- Module operates on 12v DC
- Can be used for Incubation
- Eggs Hatching
- You can control DC or AC appliances
SKU: n/a - 433 Mhz, Arduino, Arduino Components, Modules, Power, Relays, Wireless
1 Channel Wireless 433Mhz Remote Control Relay Module 220v
433 Mhz, Arduino, Arduino Components, Modules, Power, Relays, Wireless1 Channel Wireless 433Mhz Remote Control Relay Module 220v
- Input Voltage: AC85V-AC220V
- RF Frequency: 315/433MHZ
- RF Working mode:Super heterodyne receiver
- Receiver Sensitivity: -107dBm
- Remote Control Distance: >100 meter(In open environment)
- Remote Control sold seperately
- works with 433 mhz remote control with encoding type ev1527 pt2262 etc
- Decoding Way: MCU Software decoding
- Can store the number of remote control:32
- Support remote control type: Fixed code, learning code
- Channel: 1CH
SKU: n/a - Arduino, Arduino Components, Modules, Sensors
Microphone Sensor Sound Detection Module
- Operating Voltage: 3v to 5.5v
- Sound Detection Module has two output
- AO, analog output, real-time output voltage signal of the microphone
- DO, when the sound intensity reaches a certain threshold, the output high and low signal
SKU: n/a - Components, Connectors, Programmer Accessories, Wires and Cables
DB25 25 Pin Parallel Cable Case With Screws
Components, Connectors, Programmer Accessories, Wires and CablesDB25 25 Pin Parallel Cable Case With Screws
This is a standard 25Pin DB25 Parallel Cable Case with good quality plastic material & screws for DB25 Male or female connectors, solder a wire with the connector & put it in this case & tighten the screws to make a good quality parallel cable, tightening the screws carefully always ensures the good connection between wire & connector.
- Type: Solder Type Plug
- Body Orientation: Straight
- Gender: For (Male & Female)
- Good Quality Plastic Material
SKU: n/a - Arduino Components, Arduino Shields, Development Boards, Modules
HW-584 RJ45 Network Internet Relay Control Switch 5v W5100
Arduino Components, Arduino Shields, Development Boards, ModulesHW-584 RJ45 Network Internet Relay Control Switch 5v W5100
- Model: HW-584
- Channel: 8 Channel, 16Channel (Both relay boards Supported)
- External power supply voltage: 5V DC 2A
- Network assistant set serial port
- Protocol: TCP/IP
- IP: 192.168.1.4
- Port number: 3000
SKU: n/a - Arduino, Arduino Components, Modules, Power, Relays, Sensors
XH-W1219 LED Digital Thermostat Temperature Controller
Arduino, Arduino Components, Modules, Power, Relays, SensorsXH-W1219 LED Digital Thermostat Temperature Controller
- This is Universal Digital Thermostat
- Temperature Control Module can be used to control the temperature of anything (Solid or Liquid or Air)
- Set the Specific Temperature You Want to Maintain.
- Module operates on 12v DC
- You can control DC or AC Appliances
- Recommended for Incubation
SKU: n/a - Components, Modules
TPA3116D2 XH-M189 Digital HIFI Power Amplifier Board 2 X 50W
- Model XH-M189 TPA3116 D2
- Input Voltage 5-24V
- Digital Power Amplifier Board
- Audio Type: TPA3116D2
- Input Voltage: DC 5V~DC 24V
- Output Power: 2 x 50 W
- Operating Frequency: 20Hz – 20Hz
- Output type: Double Track Stereo
- Size(L*W*H): 10 x 5 x 2.2 cm
SKU: n/a - Programmers
SP200S SP200SE Programmer For PIC ATMEL MICROCHIP SST ST WINBOND
- Supports USB1.1 or USB2.0 communications ;
- Fully support WIN98 , WINME, WIN2000 , WINXP, VISTA, WIN7 32 – bit and 64 – bit operating systems ;
- Supports Atmel , Microchip , SST, ST, WINBOND, STC, MSP430 and other branded hundreds of models MCU and EEPROM programming ;
- Using USB port power supply , power line data set , notebook users ;
- Standard IDC10PIN interface 5.ISP interface using the Atmel company recommended ;
- USB-TTL interface is used for STC ( cold start it manually ) and MSP430 BSL series program download ;
- Perfect SP200SE programmer , using the SP200SE software interface , supports both Chinese and English Languages
SKU: n/a - Other
USB 2.0 Micro SD TF Flash Memory Card Reader
- SDHC micro Card Reader/Writer.
- Support USB version Micro SD 1.1/2.0 and Micro SDHC 2.0.
- Plug and play hot swapping,easy to install and use.
- High speed data transmission.
- Power supply : by USB port directly.
- Single card reader ,slim size,easy for carry.
- Rope hole for hang.
- Material:Plastic
- Size:3.2cmX1.6cm
SKU: n/a - Arduino, Robotics
Mini Micro 9g 1.6KG Servo SG90
- Model: SG90
- Technical data given by the manufacturers:
- Size: 21.5mmX11.8mmX22.7mm
- Weight: 9 grams
- No-load speed: 0.12 seconds / 60 degrees (4.8V)
- Stall torque of 1.2 – 1.4 kg / cm (4.8V)
- Operating temperature: -30 to +60 degrees Celsius
- Dead-set: 7 microseconds
- Operating voltage: 4.8V-6V
SKU: n/a - Development Boards, STMicroelectronics, Tools
DSO138 2.4″ TFT Digital Oscilloscope 1Msps with free Probe
Development Boards, STMicroelectronics, ToolsDSO138 2.4″ TFT Digital Oscilloscope 1Msps with free Probe
- Fully Assembled Kit (Soldered)
- This DSO138 digital oscilloscope kit adopts ARM Cortex-M3 processor and with 2.4-inch TFT screen.
- It’s easy and reliable for circuit operation.
- It can display frequency, period, pulse width, duty ratio, MAX./MIN./AVG./Peak-Peak/virtual values.
SKU: n/a - Power, Relays
4 Channel 5v Optically Isolated Relay Module
- Operating Voltage: 5v DC
- Relay contact capacity: 250v AC 10A, or 30v DC 10A
- Optically Isolated from Mains
- Relay output: normally open, normally closed
- Low level Trigger
- signal input voltage range: 0 – 5 v
- Compatible with Arduino, PIC, AVR etc
SKU: n/a
