Motion Sensor
Showing all 7 resultsSorted by popularity
- Arduino, Arduino Components, Modules, Sensors
HC-SR501 PIR Infrared Motion Sensor Detector Module
- Color: White + Green
- Dimension: 3.2cm x 2.4cm x 1.8cm (approx)
- Infrared sensor with control circuit board
- The sensitivity and holding time can be adjusted
- Working Voltage Range: DC 4.5V- 20V
- Current drain:<60uA
SKU: n/a - Arduino, Arduino Components, Modules, Sensors
Infrared Reflective Obstacle Avoidance Sensor
- Sensor module output port OUT can be directly connected with the microcontroller IO port.
- Can also directly drive a 5V relay; Connection: VCC-VCC; GND-GND; OUT-IO
- The Comparator with LM393, Stable.
- Can be used 3.3V-5V DC power supply module. When the power is turned on, the red power indicator light;
- VCC external 3.3V-5V voltage (can be directly connected with the 5v microcontroller or 3.3v single-chip)
- GND external GND
- OUT small board digital output interface (0 and 1)
SKU: n/a - Modules, Power, Relays
Automatic Light On Off Body Motion Microwave Sensor Switch 220V
- This Switch can be used to Automatically Turn ON & OFF Light, Incandescent & CFL Based on Motion Detection.
- For example It will turn on the lights when there is Human Motion detected in the room.
- It will automatically turn off the lights after specific time when motion is not detected.
- Power Saving & Energy Efficient Device
SKU: n/a - Arduino, Arduino Components, Sensors
HW-MS03 Microwave Radar Human Inductive Motion Sensor
- Category: Digital sensor
- Sensor Type: 2.4GHz / 5.8Ghz radar sensors
- Independent of temperature, humidity, airflow, dust, noise, light and dark and other effects, anti-jamming;
- The microwave transceiver module is a field-shaped signal, wide coverage and no blind spots;
- During transmission of microwave induced effect is relatively good: when used indoors
SKU: n/a - Arduino, Arduino Components, Modules, Sensors
Infrared Reflective Obstacle Tracking Sensor TCRT5000
- Sensor module output port OUT can be directly connected with the microcontroller IO port.
- Can also directly drive a 5V relay; Connection: VCC-VCC; GND-GND; OUT-IO
- The Comparator with LM393, Stable.
- Can be used 3.3V-5V DC power supply module. When the power is turned on, the red power indicator light;
- VCC external 3.3V-5V voltage (can be directly connected with the 5v microcontroller or 3.3v single-chip)
- GND external GND
- OUT small board digital output interface (0 and 1)
SKU: n/a

USBASP USBISP Programmer for ATMEL AVR ATMega ATTiny
MXIC MX25L3206E Flash Memory Chip 32Mbit 4MB
RP920124 6Pin Relay 24v Coil 250V AC 8A
AC-DC 9V 1A 9W Isolated Branded Power Supply
DS1307 AT24C32 Real Time Clock module with EEPROM
HW-MS03 Microwave Radar Human Inductive Motion Sensor




