All Products
Showing 25–48 of 444 resultsSorted by popularity
- Components, IC
RDA5815M 5815M QFN-20 Signal IC
- RDA5815M is the fourth-generation satellite receiver radio frequency front-end chip that RDA rolled out in 2012.
- It is compatible with all DVB-S, DVB-S2&ABS satellite modes.
- The chip features superior performance, ultra-wide dynamic range (100dB), minimum noise coefficient (MAX 5.5) and good linearity.
SKU: n/a - Components, Diode, Diode Bridge
DB107S Single Phase Bridge Rectifier SOP-4
- Model: DB107 DB107S
- Maximum repetitive peak reverse voltage 1000V
- Maximum RMS bridge input voltage 700V
- Maximum DC blocking voltage 1000V
- Maximum average forward rectified output current at TA=100C 1A
- Operating junction and storage temperature range -50 to 150C
SKU: n/a - Components, Programmer Components, Programmers, SPI Flash Memory
MXIC MX25L6406E Flash Memory Chip 64Mbit 8MB
Components, Programmer Components, Programmers, SPI Flash MemoryMXIC MX25L6406E Flash Memory Chip 64Mbit 8MB
- Memory
- 64Megabits = 8Megabyte (MB)
- Voltage
- 2.7V to 3.6V
This is MXIC 8MB SPI Memory Chip.
Can be used in thousands of supported devices. for example routers, dish receivers, set top boxes, CPEs, lcds, laptops etc
SKU: n/a - Memory
- Components, Programmer Components, Programmers, SPI Flash Memory
cFeon Q32B Flash Memory Chip 32Mbit 4MB
Components, Programmer Components, Programmers, SPI Flash MemorycFeon Q32B Flash Memory Chip 32Mbit 4MB
- Single power supply operation
- Full voltage range: 2.7-3.6 volt
- Serial Interface Architecture
- SPI Compatible: Mode 0 and Mode 3
- 32 M-bit Serial Flash
- 32 M-bit/4096 K-byte/16384 pages
- 256 bytes per programmable page
- Standard, Dual or Quad SPI
- Standard SPI: CLK, CS#, DI, DO, WP#
- Dual SPI: CLK, CS#, DQ0, DQ1, WP#
- Quad SPI: CLK, CS#, DQ0, DQ1, DQ2, DQ3
SKU: n/a - Single power supply operation
- Components, Power, Voltage Converters, Voltage Regulators
AMS1117 1.2v 800mA Low Dropout Voltage Regulator
Components, Power, Voltage Converters, Voltage RegulatorsAMS1117 1.2v 800mA Low Dropout Voltage Regulator
- Module property:Non-isolation Linear Regulator
- Rectification mode: None
- Input Voltage: 2V-6V
- Output Voltage: 1.2v
- Rated Output Current: 800ma Maximum (Not to be exceeded)
- Conversion Efficiency: >60%
- Switching Frequency: As Input
- Voltage regulation:± 2.5%
- Work temperature: -Minus 40 Degrees 85 Degrees
SKU: n/a - Components, IC, Power, Voltage Converters
TNY277PN Power Managment IC
- Manufacturer: Power Integrations
- Product Category: AC/DC Converters
- Mounting Style: Through Hole
- Package/Case: DIP-7
- Output Voltage: 12 V
- Output Power: 18 W
- Input / Supply Voltage – Min: 85 VAC
- Input / Supply Voltage – Max: 265 VAC
- Switching Frequency: 132 kHz
- Duty Cycle – Max: 65 %
SKU: n/a - Components, Diode, Diode Bridge
KBP310 Single Phase Silicon Bridge Rectifier 3A
- Model: 3A Single-Phase Silicon Bridge Rectifier
- Maximum repetitive peak reverse voltage 1000V
- Maximum RMS bridge input voltage 700V
- Maximum DC blocking voltage 1000V
- Maximum average forward rectified output current at 3A
- Operating junction and storage temperature range -50 to 150C
SKU: n/a - Components, Programmer Components, Programmers, SPI Flash Memory
WINBOND W25Q64 Flash Memory Chip 64Mbit 8MB
Components, Programmer Components, Programmers, SPI Flash MemoryWINBOND W25Q64 Flash Memory Chip 64Mbit 8MB
- Memory
- 64Megabits = 8Megabyte (MB)
- Voltage
- 2.7V to 3.6V
This is Original WINBOND 8MB SPI Memory chip.
Can be used in thousands of supported devices. for example routers, dish receivers, set top boxes, CPEs, lcds, laptops etc
SKU: n/a - Memory
- Components, IC, Power, Power Management, Transistor, Voltage Converters
TL431A TL431 SOT-23 Voltage Refrence Power Supply Feedback Regulator
Components, IC, Power, Power Management, Transistor, Voltage ConvertersTL431A TL431 SOT-23 Voltage Refrence Power Supply Feedback Regulator
TL431A is a power supply feedback transistor chip used in variety of ac to dc switching power supplies.
- Part Number: TL431A
- Programmable output voltage upto 2.5v to 40v
- Output voltage can be set by 2 resistor divider between Positive & Negative output of the supply.
SKU: n/a - Modules, Power, Voltage Converters
TP4056 03962A Lithium Battery Charger with Protection Module
- Current- 1A adjustable.
- Charge precision- 1.5%.
- Input voltage- 4.5V-5.5V.
- Full charge voltage- 4.2V.
- Led indicator- red is charging Green is full charged.
- Input interface- micro USB & welding points
- Work temperature- -10° to +85°.
- Reverse polarity protection: No
- Size- small to 25X19X10mm.
- works with all types of lipo & lithium batteries like 18650
- Connect Battery with B+ & B-
- Connect Battery load OUT+ & OUT – (this is uninterrupted power supply)
SKU: n/a - Components, IC
TDA2030A 18W HI-FI Audio Amplifier IC
- Power: 18W
- Small size IC(package PENTAWATT V, almost size of regular TO220)
- Maximum voltage range (upto 44Volts Vs MAx)
- Very low harmonic and cross-over distortion
- Suited for more reliable applications without regulated supply
- Up to 35 Watts RMS driver output
- Thermal Shutdown Protection
SKU: n/a - Components, IC, Power, Voltage Converters
SD6830 PWM PFM Power Management IC
- SD6830 is current mode PWM+PFM controller with built-in high-voltage MOSFET used for SMPS.
- It features low standby power and low start current. In standby mode, the circuit enters burst mode to reduce the standby power dissipation.
- The switch frequency is 25~67KHz decided by the load with jitter frequency for low EMI.
- Built-in peak current compensation circuit makes the limit peak current stable even with different input AC voltage.
- Maximum peak current compensation during power-on reduces pressure on transformer to avoid saturation, the peak current compensation will decrease for balance after power-on.
- Limit output current can be adjusted through the resistor connected to CS
SKU: n/a - Components, Modules
PAM8610 Digital Amplifier Board 15W x 2
- 2 * 15W D Class
- Supply voltage: DC 7V-15V
- Output power: 10w + 10w (8 load)
- Efficiency: 90%
- Shutdown Current: 4uA
- Quiescent current; 20mA
- SNR: 86%
- Total harmonic distortion: 5W / 1KHz / 8 —- 0.1%
- Frequency range: 20Hz-20KHz
- Input impedance: 15K
- Output Impedance: 4-8
- Amplifier board size: 30mm * 25mm * 2.5mm
SKU: n/a - Components, Modules
TPA3116D2 Digital HIFI Power Amplifier Board 2 X 120W
- Input Voltage 5-28V (more than 28V overvoltage protection)
- Support for low power 5V such as USB power supply
- Can also support high power 28V such as dual battery power supply
- Recommended power supply DC24V peak current 6A
- Output Maximum Power Up to 120W per channel
- Support 4 -8 Ohm speaker
SKU: n/a

LM317T LM317 TO-220 1.2V To 37V 1.5A Adjustable Voltage Regulator
TTP229 16 Channel Digital Capacitive Touch Module
PAM8403 5v Digital Amplifier Board with Potentiometer
















