- ×
CR2032 Single Use Battery 3v1 × ₨40 - ×
MXIC MX25L3206E Flash Memory Chip 32Mbit 4MB1 × ₨100 - ×
PLCC44 to DIP40 IC Adapter Socket Converter1 × ₨650 - ×
RP710024 Relay 24v Coil 250V AC 16A1 × ₨600
Subtotal: ₨1,390
All Products
Showing 385–408 of 444 resultsSorted by popularity
- Arduino, Arduino Components, GSM, Modules, Wireless
M590E GPRS GSM Module Dual Band
- Ready to use module
- Chip: M590E
- Voltage: 5v
- Best for SMS GPRS
- Support networks: GSM 900 & GSM 1800 Network
- Module size: 50mm*50mm
- TTL serial port for serial port, you can link directly to the microcontroller. No need MAX232
- Power module automatically boot on home network
- Onboard status LED.
SKU: n/a - 2.4 Ghz, Arduino, Arduino Components, Modules, Wireless
ESP8285 ESP-M3 Wifi Serial Transceiver Module
2.4 Ghz, Arduino, Arduino Components, Modules, WirelessESP8285 ESP-M3 Wifi Serial Transceiver Module
Features:
- Breadboard Friendly
- Built-in Tensilica L106 ultra-low power 32-bit microprocessor, clocked at 80MHz and 160MHz support RTOS
- Built-in TCP / IP protocol stack
- Built-in 1-channel 10-bit high-precision ADC
- Peripheral Interface HSPI, UART, I2C, I2S, IR Remote Control, PWM, GPIO
- The deep sleep hold current is 10uA and the shutdown current is less than 5uA
- Wake up within 2 ms, connect and pass the packet
- Standby power consumption less than 1.0mW (DTIM3)
- Built-in 1M bytes of SPI Flash
SKU: n/a - 2.4 Ghz, Arduino, Arduino Components, Development Boards, Espressif, Modules, Wireless
ESP-201 ESP8266-201 Wifi Transceiver Module
2.4 Ghz, Arduino, Arduino Components, Development Boards, Espressif, Modules, WirelessESP-201 ESP8266-201 Wifi Transceiver Module
- ESP8266 – 201 WIFI Wireless Transceiver Module
- Compatible with Arduino IDE & NodeMCU
- Condition: New
- Can be used as the IO module
- All IO lead out
- With antenna, farther than others
- IPX interface on board
- Low power consumption
SKU: n/a - Modules, Power, Voltage Converters
DC 12V to DC 5V 3A 15W Converter Power Adapter
- Fully Isolated StepDown Converter for car power
- Synchronous rectification, the conversion rate is ≥96%, very low heat.
- With overload/over-current/over temperature/short circuit protection, and it can work in normal condition when restored.
- All epoxy sealed containers with Waterproof Housing.
- Compact design, high efficiency, easy installation and use.
- Input: DC 8-20V
- Output: DC 5V, 3A, 15W.
- Size: 46mm X 27mm X 14mm
SKU: n/a - Arduino, Arduino Components, Modules, Sensors
Infrared Reflective Obstacle Tracking Sensor TCRT5000
- Sensor module output port OUT can be directly connected with the microcontroller IO port.
- Can also directly drive a 5V relay; Connection: VCC-VCC; GND-GND; OUT-IO
- The Comparator with LM393, Stable.
- Can be used 3.3V-5V DC power supply module. When the power is turned on, the red power indicator light;
- VCC external 3.3V-5V voltage (can be directly connected with the 5v microcontroller or 3.3v single-chip)
- GND external GND
- OUT small board digital output interface (0 and 1)
SKU: n/a - Components, IC, Power, Power Management, Transistor, Voltage Converters
TL431A TL431 TO-92 Voltage Refrence Power Supply Feedback Regulator
Components, IC, Power, Power Management, Transistor, Voltage ConvertersTL431A TL431 TO-92 Voltage Refrence Power Supply Feedback Regulator
TL431A is a power supply feedback transistor chip used in variety of ac to dc switching power supplies.
- Part Number: TL431A
- Programmable output voltage upto 2.5v to 40v
- Output voltage can be set by 2 resistor divider between Positive & Negative output of the supply.
SKU: n/a - Power, Relays
RP710024 Relay 24v Coil 250V AC 16A
- Model / Part Number: RP710024
- This Relay Module is widely used in branded UPS like APC & Dell etc
- Usually when mains voltage fluctuates a lot this relay fails, & then there is no switching or UPS cant convert to mains & remains on Backup Mode.
- By just replace this relay switching problem solves.
SKU: n/a - Arduino Components, Modules, Power, Tools
Mini Digital Panel Volt & Ampere Meter 100V 100A
- Feature:Reverse Connect Protection
- Shunt Included
- Working current of Meter itself:≤20mA
- Voltage Measuring Range: DC 0-100V
- Current Measuring Range: 0 – 100A
- Voltage resolution (V): 0.1V
- Current resolution (A): 0.01A
SKU: n/a
