Arduino Components
Showing 49–72 of 130 resultsSorted by popularity
- Arduino Components, Modules, Power, Tools
Digital Panel Voltmeter 0.36 LED Display 2.5-30V DC
- Type : 0.36 two-wire DC voltmeter
- Material: Plastic
- Size: 3.5 x 1.5 x 1cm
- Color: Black
- Display Color: Red
- Two-wire Measurement range: DC 2.5~32V
- Working Current:< 23mA
- Working Temperature: -10C-65C
- Minimum input voltage: DC 2.5V
- Maxmum input voltage: DC 32V
SKU: n/a - Arduino, Arduino Components, RFID, Wireless
125Khz RFID Tag Keychain
- Big coil, ABS material
- Strong magnetic induction
- 100% brand new and high quality
- Operation frequency: 125Khz
- Each token pre-programmed with unique ID which is printed on it
- Each comes with Key ring included
- Compatible with all RFID reader to gain access
- Card read distance: 0-10 centimetres
- Water resistant
SKU: n/a - Arduino, Arduino Components, Modules
Openlog Serial to Micro SD Data Logger Module
Log & Store Serial Interface data to MicroSD card of upto 64GB, Compatible with all Microcontrollers & Serial capable devices.
- VCC Input: 3.3V-12V (Recommended 3.3V-5V)
- Log to low-cost microSD FAT16/32 cards up to 64GB
- Simple command interface
- Configurable baud rates (up to 115200bps)
- Preprogrammed ATmega328 and bootloader
- Four SPI pogo pins
- Two LEDs indicate writing status
- 2mA idle, 6mA at maximum recording rate
- can run at least the connection for vcc, gnd, rx
SKU: n/a - Arduino, Arduino Components, Arduino Shields, Modules
A4988 3D Printer Stepper Motor Driver Module
- Crossover-current protection
- Thermal shutdown circuitry
- 3.3 and 5 V compatible logic supply
- Thermal shutdown circuitry
- Ground Fault Circuit
- Load short-circuit protection
- Of five optional step mode: full, 1/2, 1/4, 1/8 and 1/16
SKU: n/a - 433 Mhz, Arduino, Arduino Components, Modules, Wireless
SI4432 433mhz Wireless Transceiver Module
- Operating Frequency: 240Mhz – 930Mhz (customizable)
- Operating Voltage: 1.8V to 3.6V
- Current – Sleep mode : 1.0uA
- Current – Standby mode : 800nA
- Current – Receive mode : 18.5mA
- Current – Transmit mode @ +20dBm : 85mA
- Opeting Temperature: -20C to +70C
- Data rate – Maximum : 256kbps
- Transmit power : +20 dBm (Max)
- Receiver Sensetivity : -121dBm
- Range : upto 1.5km (depends upon several other parameters, hence not gauranteed)
- Module Header pin pitch: 0.05inch / 1.27mm
SKU: n/a - Arduino, Arduino Components, Modules, Sensors
SW520D Tilt Sensor Module Module
- Using high-sensitivity switch SW 520D as the sensor.
- The module is equipped with fixed bolt hole for convenient installation.
- Using LM393 wide voltage comparator,clean signal,good waveform,strong driving ability with output of more than 15 mA.
- The working voltage of 3.3V to 5V.
- Small PCB size:3.2cm x 1.4cm.
- Digital output form: digital switch output (0 and 1).
SKU: n/a - 433 Mhz, Arduino, Arduino Components, Modules, Wireless
RX470 433Mhz Superheterodyne RF Receiver Module
433 Mhz, Arduino, Arduino Components, Modules, WirelessRX470 433Mhz Superheterodyne RF Receiver Module
- Product Model: RX470B-V02
- Superheterodyne Wireless Receiver Module
- Receiving UHF ASK Demodulators
- Support ASK and OOK Modulation.
- The receiver module has high sensitivity (-108dBm),
- Low-power performance, along with high dynamic range (greater than 60dB)
SKU: n/a - Arduino, Arduino Components, Sensors
HW-MS03 Microwave Radar Human Inductive Motion Sensor
- Category: Digital sensor
- Sensor Type: 2.4GHz / 5.8Ghz radar sensors
- Independent of temperature, humidity, airflow, dust, noise, light and dark and other effects, anti-jamming;
- The microwave transceiver module is a field-shaped signal, wide coverage and no blind spots;
- During transmission of microwave induced effect is relatively good: when used indoors
SKU: n/a - 433 Mhz, Arduino, Arduino Components, Modules, Wireless
HC-12 SI4463 Wireless Serial Port Module 1000m
433 Mhz, Arduino, Arduino Components, Modules, WirelessHC-12 SI4463 Wireless Serial Port Module 1000m
- HC-12 SI4463 wireless microcontroller serial module
- 433mhz frequency with multiple channels
- 1000M extended range with antenna
- HC-12 is a wireless 433mhz transceiver module to communicate between microcontrollers through wireless link.
SKU: n/a - Arduino, Arduino Components, Sensors
Soil Moisture Detection Humidity Sensor Module
- Operating Voltage 3.3V-5V
- Module Dual Output mode , a simple digital output , analog output more accurate.
- With fixed bolt hole for easy installation
- Small PCB board size : 3cm * 1.6cm
- Power Indicator ( red ) and the digital switch output Indicator ( green )
- Using LM393 Comparator Chip , Stable
- VCC external 3.3V-5V
- GND GND External
- DO small board digital output interfaces ( 0 and 1 )
- AO small board analog output interface
SKU: n/a - 433 Mhz, Arduino, Arduino Components, Wireless
433Mhz RF Wireless Remote Control 2 Channel On Off
- This remote control only support the learning code (1527) of the receiver
- It can not clone other remote controls, it is only 1527 encoded remote control. (Fixed Code)
- Can only match the 1527 learning code receiver.
- Application: (Partial)
- Garage doors access control system
- Electronic gates access control system
- Electrical appliances control
- Vehicle central locking systems
- Car sunroofs control
- Heating systems control
SKU: n/a - 433 Mhz, Arduino, Arduino Components, Modules, Power, Relays, Wireless
1 Channel Wireless 433Mhz Remote Control Relay Module 220v
433 Mhz, Arduino, Arduino Components, Modules, Power, Relays, Wireless1 Channel Wireless 433Mhz Remote Control Relay Module 220v
- Input Voltage: AC85V-AC220V
- RF Frequency: 315/433MHZ
- RF Working mode:Super heterodyne receiver
- Receiver Sensitivity: -107dBm
- Remote Control Distance: >100 meter(In open environment)
- Remote Control sold seperately
- works with 433 mhz remote control with encoding type ev1527 pt2262 etc
- Decoding Way: MCU Software decoding
- Can store the number of remote control:32
- Support remote control type: Fixed code, learning code
- Channel: 1CH
SKU: n/a - Arduino, Arduino Components, Modules, Sensors
Microphone Sensor Sound Detection Module
- Operating Voltage: 3v to 5.5v
- Sound Detection Module has two output
- AO, analog output, real-time output voltage signal of the microphone
- DO, when the sound intensity reaches a certain threshold, the output high and low signal
SKU: n/a

WINBOND W25Q32 Flash Memory Chip 32Mbit 4MB
SOP8 SSOP8 TSSOP8 SMD to DIP8 PCB for Programmer
SOIC8 SOP8 to DIP8 Socket Adapter 200mil Wide Body
PLCC32 to DIP32 IC Adapter Socket Converter
USB to RS485 TTL Serial Converter Adapter
RS232 Serial COM Convert USB 2.0 to 9-Pin DB9 Male Adapter
DB9 9 Pin Female 2 Rows Solder Type Plug
1 Channel Wireless 433Mhz Remote Control Relay Module 12V
PAM8403 Digital Class D Audio Amplifier Board
Sound & Light Sensor Switch for Automatic Light On Off 220V
PAM8403 5v Digital Amplifier Board with Potentiometer
NRF905 Wireless Transceiver Module 433 868 915 MHz



















