No products in the cart.
All Products
Showing 169–192 of 444 resultsSorted by popularity
- Arduino Components, Modules, Power, Relays, Robotics
LED Display Automatic Cycle Delay Real Time Clock RTC Control Relay
Arduino Components, Modules, Power, Relays, RoboticsLED Display Automatic Cycle Delay Real Time Clock RTC Control Relay
- Operating voltage: 5.0V ~ 60V
- Support MicroUSB 5.0V Power Supply
- Trigger Source: Active-high (3.0V-24V),
- Output Capability: You can control the DC 30VDC 5A or 220VAC 10A device.
- Quiescent Current: 20mA; Operating Current: 50mA
- Life: more than 10 million times; Working temperature: -40-85
- This Module can be used to specifically Turn On / Turn Off an Electrical appliance on Specific Time for the specific duration
- This is Advanced Cyclic Timer Relay Module with Timer Clock function as well
SKU: n/a - Diagnostic Tools, Power, Tools
PCI Slot Motherboard Tester Diagnostic Debug Card Adapter For PC
- Intercept and hex the code of your booting computer.
- Hexadecimal character display.
- With 4 LED indicator.
- Detailed & precise LED function table and code Indication table, convenient for you consulting.
- Material: Plastic + Metal
- Main Color: Green
- Size: 6.3×4.7cm/2.48×1.85in (Approx.)
SKU: n/a - Arduino, Arduino Components, Modules, Programmers
CP2102 USB to Serial TTL Converter Micro USB
- Origional CP2102 IC Chip onboard
- Micro USB 6PIN TTL UART CP2102 Module
- On board Fuse for Short Circuit Protection
- DTR Pin for Auto Programming
- Designed to be used for USB to TTL Serial
- Built-in USB to RS232 Transfer chip
- Micro USB to TTL 6pin connector.
- 6pins for 3.3V, RST, TXD, RXD, GND & +5V.
- Temperature Range: -40degree to +85degree.
- Support: Windows, Linux & MAC
SKU: n/a - Arduino Components, Modules, Power, Tools
Digital Panel Voltmeter 0.36 LED Display 0-100V DC
- Type: 3-Wire Car Digital Voltmeter
- Material: Plastic
- Operating Voltage: DC 2.5-30V
- Operating Current: <20mA
- Measure Voltage: DC 0-100V
- Minimum Resolution: 0.1V / 0.01V
- Display: Red color, three digit, 0.36″
- Refresh Rate: About 200mS / times
SKU: n/a - Modules, Power, Voltage Converters
LTC1871 High Power 100W Digital Display Stepup Boost Module
The boost module uses advanced microcontroller and U.S. imports boost controller, it eliminates the need for a current sense resistor by utilizing the power mosfet’s on-resistance, thereby maximizing efficiency, up to 96.4%. Imported high-power low-resistance mos transistor, heavy current and high efficiency schottky, wider and thicker PCB traces, is a guarantee of high-power and low temperature rise. When the input and output voltage is greater than 20V, the module up to 128W output power.
SKU: n/a - 433 Mhz, Arduino, Arduino Components, Components, Connectors, Wireless
433MHz 5dbi Antenna SMA Male Plug with RG174
433 Mhz, Arduino, Arduino Components, Components, Connectors, Wireless433MHz 5dbi Antenna SMA Male Plug with RG174
- Frequency Range: 433+/-15MHz
- Bandwidth: 30MHz
- Max Gain: 5dBi
- Max Input Power: 60W
- Input Impedance: 50Ω
- Polarization Type Vertical
- Cable Length 1.5M
- Total length(From the top to base): 14.2cm/5.59″
- Base size: 3.5x3cm/1.38×1.18″(LxW)
- Cable Type: RG174
- Connector Type: SMA Male (Pin inside) Plug connector
- With Mounting Magnetic
SKU: n/a - Arduino, Arduino Components, Modules, Power, Robotics
NE555 PWM Pulse Signal Generator
- Used as a square wave signal generator
- offer the square wave signal for the use of the experimental development.
- Used to produce driving stepper motor drives, offer the square wave signal.
- Adjustable pulse for the use of MCU.
- Generate pulse with adjustable frequency & duty cycle.
SKU: n/a - Arduino, Arduino Components, Modules, Sensors
HC-SR501 PIR Infrared Motion Sensor Detector Module
- Color: White + Green
- Dimension: 3.2cm x 2.4cm x 1.8cm (approx)
- Infrared sensor with control circuit board
- The sensitivity and holding time can be adjusted
- Working Voltage Range: DC 4.5V- 20V
- Current drain:<60uA
SKU: n/a - Arduino, Arduino Components, Modules, Sensors
Infrared Reflective Obstacle Avoidance Sensor
- Sensor module output port OUT can be directly connected with the microcontroller IO port.
- Can also directly drive a 5V relay; Connection: VCC-VCC; GND-GND; OUT-IO
- The Comparator with LM393, Stable.
- Can be used 3.3V-5V DC power supply module. When the power is turned on, the red power indicator light;
- VCC external 3.3V-5V voltage (can be directly connected with the 5v microcontroller or 3.3v single-chip)
- GND external GND
- OUT small board digital output interface (0 and 1)
SKU: n/a - Components, Connectors
USB 3.0 To 22Pin High Speed SATA Hard Disk Cable
- USB 3.0 Interface for High Speed Data Transmission
- 22Pin SATA is (7pin+15Pin).
- No Separate Power Supply Required
- Your desktop will have to support USB 3.0 (Also Backward Compatible with USB 2.0)
- The Cable supports 5V SATA 22 Pin HDD Adapter Cable.
- It supports with 2.5″ SATA HDD & SSD & DVD Players
- Plug & Play
SKU: n/a - Modules, Power, Voltage Converters
XL4016 DC-DC 200W 8A Step Down Buck Converter
- Input voltage: DC 4-38V
- Output voltage: DC 1.25-36V
- Maximum current: 8A
- Maximum power: 200W
- Conversion efficiency: 95%
- Working Temperature: -45~+85℃
- Size: 6×3.7cm/2.36×1.46inch
- Voltage Regulating Mode: PWM Modulation
- Switching Frequency: 180KHz
SKU: n/a - Components, Programmer Components, Programmers, SPI Flash Memory
GigaDevice GD25Q64 Flash Memory Chip 64Mbit 8MB
Components, Programmer Components, Programmers, SPI Flash MemoryGigaDevice GD25Q64 Flash Memory Chip 64Mbit 8MB
- Memory
- 64Megabits = 8Megabyte (MB)
- Voltage
- 2.7V to 3.6V
- Family of SpiFlash Memories
- GD25Q64: 64M-bit / 8M-byte
- 256-bytes per programmable page
- Standard, Dual or Quad SPI
- Standard SPI: CLK, /CS, DI, DO, /WP, /Hold
- Dual SPI: CLK, /CS, IO0, IO1, /WP, /Hold
- Quad SPI: CLK, /CS, IO0, IO1, IO2, IO3
- Highest Performance Serial Flash
- Up to 6X that of ordinary Serial Flash
- 80MHz clock operation
- 160MHz equivalent Dual SPI
- 320MHz equivalent Quad SPI
- 40MB/S continuous data transfer rate
- 30MB/S random access (32-byte fetch)
- Comparable to X16 Parallel Flash
SKU: n/a - Memory
- 433 Mhz, Arduino, Arduino Components, Modules, Wireless
RX470 433Mhz Superheterodyne RF Receiver Module
433 Mhz, Arduino, Arduino Components, Modules, WirelessRX470 433Mhz Superheterodyne RF Receiver Module
- Product Model: RX470B-V02
- Superheterodyne Wireless Receiver Module
- Receiving UHF ASK Demodulators
- Support ASK and OOK Modulation.
- The receiver module has high sensitivity (-108dBm),
- Low-power performance, along with high dynamic range (greater than 60dB)
SKU: n/a - Arduino Components, Modules, Power, Tools
Digital Panel Voltmeter 0.36 LED Display 2.5-30V DC
- Type : 0.36 two-wire DC voltmeter
- Material: Plastic
- Size: 3.5 x 1.5 x 1cm
- Color: Black
- Display Color: Red
- Two-wire Measurement range: DC 2.5~32V
- Working Current:< 23mA
- Working Temperature: -10C-65C
- Minimum input voltage: DC 2.5V
- Maxmum input voltage: DC 32V
SKU: n/a - Modules, Power, Voltage Converters
DC-DC 8V-35V To 5V 8A Step Down Power Charger Module
- DC-DC 8V35V To 5V 8A StepDown Power Charger Module
- 4 USB Ports Output
- 4 Independant Controller IC for Each USB Port
- Conveniently use with any 12v to 24v adapter
- For Multiple USB power supply needs
- Power Hungry Devices Tablets, Pads, Cell Phones.
SKU: n/a - 433 Mhz, Arduino, Arduino Components, Wireless
433Mhz RF Wireless Remote Control 4 Channel
- Clone your existing 433mhz Remote Control Key FOB
- Working voltage: DC 12V (built-in battery)
- Compatible with Arduino & 433mhz receiver
- Operating Current: <25ma
- Transmitting frequency: 433Mhz
- Key number: 4 Key (4 Channel)
- Emission Distance: 70-100m (Open area)
- Encoding type: fixed code (1527)
- Color: Silver Black
- Case material: Metal and PVC
SKU: n/a - 433 Mhz, Arduino, Arduino Components, Modules, Wireless
SI4432 433mhz Wireless Transceiver Module
- Operating Frequency: 240Mhz – 930Mhz (customizable)
- Operating Voltage: 1.8V to 3.6V
- Current – Sleep mode : 1.0uA
- Current – Standby mode : 800nA
- Current – Receive mode : 18.5mA
- Current – Transmit mode @ +20dBm : 85mA
- Opeting Temperature: -20C to +70C
- Data rate – Maximum : 256kbps
- Transmit power : +20 dBm (Max)
- Receiver Sensetivity : -121dBm
- Range : upto 1.5km (depends upon several other parameters, hence not gauranteed)
- Module Header pin pitch: 0.05inch / 1.27mm
SKU: n/a - 433 Mhz, Arduino, Arduino Components, Wireless
433Mhz RF Wireless Remote Control One Key
- Working voltage: DC 12V (built-in button battery)
- Compatible with Arduino & 433mhz receiver
- Operating Current: 10MA
- Transmitting frequency: 433Mhz
- Key number: 1 Key
- Emission Distance: 20-70m (Open area)
- Encoding type: fixed code (1527,1538)
- Oscillation resistance: 4.7m/15.42ft (Approx.)
- Size: (Dia×H) 4.5×1cm/1.77×0.39in (Approx.)
- Color: White
- Case material: Plastic
SKU: n/a
